D-35, D-44 & DIY C&T

D-35, D-44 & DIY C&T

As the 1st company in 2011 to ever to offer a D-35 & D-44 Billet C&T...We are now offering it in DIY kit! This is the easiest and strongest way to do a C&T and can be done with a 4.5" angle grinder with a thin cutt off wheel, and of course your welder. This can even be done while your beams are still on the truck, but it is much easier to do with them off and takes less then an hour to do for your average fabricator. 

 

Basic instructions:

 The C&T comes pre set into the new beam ends so all you need to do is cut the  2 small welds on each side of the lower beam end on the inside, then cut tight around the lower beam end on the bottom side, remove the old lower beam end, then slide your new lower beam end in and weld it up, then weld in the upright gussets and filler plates. 

  • Terms & Conditions

    We ship FedEx & USPS. Products shipped USPS will ship directly to you. Products shipped through FedEx will ship to your nearest FedEx location where you will have to pick it up unless you request it to be shipped directly to you. If you choose to do so please contact us, or type it in the notes section when you check out & we will bill you separately for the cost difference to ship directly to you.  We will NOT be held responsible for lost, stolen packages. Once they leave here you will receive a tracking number/numbers and it becomes 100% your responsibility. All of our products are built to order. No refunds or exchanges at anytime! By placing your order you agree to our terms. 

     

$445.00 Regular Price
$375.00Sale Price